International Journal of Nanoscience and Nanotechnology

International Journal of Nanoscience and Nanotechnology

Nano-Zeolite Additive Effects on Rheological and Filtration Attributes of Ca-Bentonite Solutions

Document Type : Research Paper

Authors
1 Faculty of Petroleum and Petrochemical Engineering, Hakim Sabzevari University, Sabzevar, Khorasan Razavi, Iran
2 Petroleum Engineering Department, School of Chemical and Petroleum Engineering, Shiraz University, Shiraz, Fars, Iran
Abstract
   In the drilling fluid industry, nanoparticles (NPs) are among the most promising additives for improving the properties of drilling fluids. The present study aims at investigating the impacts of clinoptilolite, as a prevalent type of zeolite, on the flow behavior and filtration attributes of water-based drilling muds (WBMs). The nano-clinoptilolite was prepared and added to selected WBM samples at different concentrations. The results revealed that the plastic viscosity increases due to the addition of nano-clinoptilolite. This improvement helps the removal of cuttings although it could lead to pressure spikes at the beginning of the circulation. The gel strength and yield stress also increase with increasing nano-clinoptilolite content. Furthermore, these two parameters increase with increasing temperature. The plastic viscosity is adversely affected by increasing temperature. The improved rheological parameters are important in enhancing the cutting transport capacity of drilling fluids and the efficient hole-cleaning process. Furthermore, detailed curve-fitting analyses suggested the Herschel-Buckley equation as the best-fit model to the measured data. In addition, the results of filtration analyses showed that the application of nanomaterials in the selected WBMs resulted in the creation of thin impermeable mud cakes across the formation.  A significant reduction in the filtrate volume of drilling fluids is also observed. The reduction in filtration volume resolves the issues related to the formation damage and improves the efficiency of reservoir production.
Keywords

Subjects


  1. Hajiabadi, S. H., Aghaei, H., Kalateh-Aghamohammadi, M., Sanati, A., Kazemi-Beydokhti, A., Esmaeilzadeh, F., "A comprehensive empirical, analytical and tomographic investigation on rheology and formation damage behavior of a novel nano-modified invert emulsion drilling fluid", J. Pet. Sci. Eng., 181 (2019) 106257.
  2. Kazemi-Beydokhti, A., Hajiabadi, S. H., "Rheological investigation of smart polymer/carbon nanotube complex on properties of water-based drilling fluids", Colloids Surf. A: Physicochem. Eng. Asp., 556 (2018) 23-29.
  3. Kazemi-Beydokhti, A., Hajiabadi, S. H., Sanati, A., "Surface modification of carbon nanotubes as a key factor on rheological characteristics of water-based drilling muds", Iran. J. Chem. Chem. Eng., 37 (2018) 1-14.
  4. Zoveidavianpoor, M., Samsuri, A., "The use of nano-sized Tapioca starch as a natural water-soluble polymer for filtration control in water-based drilling muds", J. Nat. Gas Sci. Eng., 34 (2016) 832-840.
  5. Bourgoyne Jr, A. T., Millheim, K. K., Chenevert, M. E., Young Jr, F. S., "Applied drilling engineering. Volume 2", (1986).
  6. Darley, H. C. H., "Composition and Properties of Drilling and Completion Fluids (Fifth Edition)". Boston: Gulf Professional Publishing (1988) ix.
  7. Fink, J., "Petroleum engineer's guide to oil field chemicals and fluids": Gulf Professional Publishing (2021).
  8. Operations, D. I. M., Dresser Industries, i. O. P. D. M. O., "Drilling Fluid Engineering Manual": Magcobar Operations, Oilfield Products Division, Drosser Industries Incorporated (1972).
  9. Wang, F., Tan, X., Wang, R., Sun, M., Wang, L., Liu, J., "High temperature and high pressure rheological properties of high-density water-based drilling fluids for deep wells", Pet. Sci., 9 (2012) 354-362.
  10. Shakib, J. T., Kanani, V., Pourafshary, P., "Nano-clays as additives for controlling filtration properties of water–bentonite suspensions", J. Pet. Sci. Eng., 138 (2016) 257-264.
  11. Fereydouni, M., Sabbaghi, S., Saboori, R., Zeinali, S., "Effect of polyanionic cellulose polymer nanoparticles on rheological properties of drilling mud", Int. J. Nanosci. Nanotechnol., 8 (2012) 171-174.
  12. Benna, M., Kbir-Ariguib, N., Magnin, A., Bergaya, F., "Effect of pH on rheological properties of purified sodium bentonite suspensions", J. Colloid Interface Sci., 218 (1999) 442-455.
  13. Versan Kok, M., "Rheological and thermal analysis of bentonites for water base drilling fluids", Energy Sources, 26 (2004) 145-151.
  14. Hajiabadi, S. H., Esmailnezhad, E., Sanati, A., "Experimental investigation of the filtration properties of drilling muds formulated with magnetic water", Int. J. Pet. Geosci. Eng., 3 (2015) 9-16.
  15. Abu-Jdayil, B., "Rheology of sodium and calcium bentonite–water dispersions: Effect of electrolytes and aging time", Int. J. Miner. Process., 98 (2011) 208-213.
  16. Sadeghalvaad, M., Sabbaghi, S., "The effect of the TiO2/polyacrylamide nanocomposite on water-based drilling fluid properties", Powder Technol., 272 (2015) 113-119.
  17. Duman, O., Tunç, S., "Electrokinetic and rheological properties of Na-bentonite in some electrolyte solutions", Micropor. Mesopor. Mat., 117 (2009) 331-338.
  18. Temraz, M. G., Hassanien, I., "Mineralogy and rheological properties of some Egyptian bentonite for drilling fluids", J. Nat. Gas Sci. Eng., 31 (2016) 791-799.
  19. Luckham, P. F., Rossi, S., "The colloidal and rheological properties of bentonite suspensions", Adv. Colloid Interface Sci., 82 (1999) 43-92.
  20. Aftab, A., Ismail, A., Ibupoto, Z., "Enhancing the rheological properties and shale inhibition behavior of water-based mud using nanosilica, multi-walled carbon nanotube, and graphene nanoplatelet", Egypt. J. Pet., 26 (2017) 291-299.
  21. Dargahi-Zaboli, M., Sahraei, E., Pourabbas, B., "Hydrophobic silica nanoparticle-stabilized invert emulsion as drilling fluid for deep drilling", Pet. Sci., 14 (2017) 105-115.
  22. Esmaeilnezhad, E., Hajiabadi, S. H., Choi, H. J., "Effect of medium viscosity on rheological characteristics of magnetite-based magnetorheological fluids", J. Ind. Eng. Chem., 80 (2019) 197-204.
  23. Hajiabadi, S. H., Bedrikovetsky, P., Mahani, H., Khoshsima, A., Aghaei, H., Kalateh-Aghamohammadi, M., Habibi, S., "Effects of surface modified nanosilica on drilling fluid and formation damage", J. Pet. Sci. Eng., 194 (2020) 107559.
  24. Kazemi-Beydokhti, A., Meyghani, N., Samadi, M., Hajiabadi, S. H., "Surface modification of carbon nanotube: Effects on pulsating heat pipe heat transfer", Chem. Eng. Res. Des., 152 (2019) 30-37.
  25. Hajiabadi, S. H., Aghaei, H., Kalateh-Aghamohammadi, M., Shorgasthi, M., "An overview on the significance of carbon-based nanomaterials in upstream oil and gas industry", J. Pet. Sci. Eng., 186 (2020) 106783.
  26. Agwu, O. E., Akpabio, J. U., Ekpenyong, M. E., Inyang, U. G., Asuquo, D. E., Eyoh, I. J., Adeoye, O. S., "A critical review of drilling mud rheological models", J. Pet. Sci. Eng., 203 (2021) 108659.
  27. Ismail, A. R., Rashid, N. M., Jaafar, M. Z., Sulaiman, W. R. W., Buang, N. A., "Effect of nanomaterial on the rheology of drilling fluids", J. Appl. Sci., 14 (2014) 1192-1197.
  28. Fazelabdolabadi, B., Khodadadi, A. A., Sedaghatzadeh, M., "Thermal and rheological properties improvement of drilling fluids using functionalized carbon nanotubes", Appl. Nanosci., 5 (2015) 651-659.
  29. Riveland, F. A.: Institutt for petroleumsteknologi og anvendt geofysikk (2013).
  30. Hassani, S. S., Amrollahi, A., Rashidi, A., Soleymani, M., Rayatdoost, S., "The effect of nanoparticles on the heat transfer properties of drilling fluids", J. Pet. Sci. Eng., 146 (2016) 183-190.
  31. Cheraghian, G., "Application of nano-particles of clay to‎ improve drilling fluid", Int. J. Nanosci. Nanotechnol., 13 (2017) 177-186.
  32. Cheraghian, G., "Nanoparticles in drilling fluid: A review of the state-of-the-art", J. Mater. Res. Technol., 13 (2021) 737-753.
  33. Mokhtari-Hosseini, Z. B., Kazemiyan, E., Tayebee, R., Shenavaei-Zare, T., "Optimization of ammonia removal by natural zeolite from aqueous solution using response surface methodology", Hem. Ind., 70 (2016) 21-29.
  34. Ondrušová, D., Buňová, L., Ďurčeková, M., Domčeková, S., Pajtášová, M., Liptáková, T., "Influence of silanization conditions of filler based on clinoptilolite on its efficiency in polymeric systems", Procedia Eng., 136 (2016) 321-327.
  35. Tosheva, L., Valtchev, V. P., "Nanozeolites: synthesis, crystallization mechanism, and applications", Chem. Mat., 17 (2005) 2494-2513.
  36. Olad, A., Khatamian, M., Naseri, B., "Preparation of polyaniline nanocomposite with natural clinoptilolite and investigation of its special properties", Int. J. Nanosci. Nanotechnol., 6 (2010) 43-52.
  37. Charkhi, A., Kazemian, H., Kazemeini, M., "Optimized experimental design for natural clinoptilolite zeolite ball milling to produce nano powders", Powder Technol., 203 (2010) 389-396.
  38. Seraj, S., Ferron, R. D., Juenger, M. C., "Calcining natural zeolites to improve their effect on cementitious mixture workability", Cem. Concr. Res., 85 (2016) 102-110.
  39. Caenn, R., Darley, H. C., Gray, G. R., "Composition and properties of drilling and completion fluids": Gulf professional publishing (2011).
  40. Bahrainian, S. S., Nabati, A., Haji Davalloo, E., "Improved Rheological Model of Oil-Based Drilling Fluid for South-western Iranian Oilfields", J. Pet. Sci. Technol., 8 (2018) 53-71.
  41. Kania, D., Yunus, R., Omar, R., Abdul Rashid, S., Mohamad Jan, B., "A review of biolubricants in drilling fluids: Recent research, performance, and applications", J. Pet. Sci. Eng., 135 (2015) 177-184.
  42. Vryzas, Z., Arkoudeas, P., Mahmoud, O., Nasr-El-Din, H., Kelessidis, V., "Utilization of Iron Oxide Nanoparticles in Drilling Fluids Improves Fluid Loss and Formation Damage Characteristics", (2015).
  43. Mintova, S., Jaber, M., Valtchev, V., "Nanosized microporous crystals: emerging applications", Chem. Soc. Rev., 44 (2015).
  44. Jamshidnezhad, M., "Experimental Design in Petroleum Reservoir Studies". Boston: Gulf Professional Publishing (2015) ix-x.
  45. Villar, M. V., Lloret, A., "Influence of dry density and water content on the swelling of a compacted bentonite", Appl. Clay Sci., 39 (2008) 38-49.
  46. Chesser, B. G., Clark, D. E., Wise, W. V., "Dynamic and Static Filtrate-Loss Techniques for Monitoring Filter-Cake Quality Improves Drilling-Fluid Performance", SPE Drill. Complet., 9 (1994) 189-192.
  47. Zain, Z. M., Suri, A., Sharma, M. M., "Mechanisms of Mud Cake Removal During Flowback", SPE International Symposium on Formation Damage Control, (2000).